Sharing Electronics Projects

PCB-design

petrus bitbyter's picture
Attachments: 
0 photos | 0 schematics | 3 PCB(s) | 0 software files | 0 other
You have to be logged in to open attachments
9140804190
petrus bitbyter's picture

Submitted by petrus bitbyter on 29 August 2014 - 12:51pm.

So I did a stereo PCB-design. Tried to keep it single sided but could had to accept four wire bridges. The design is more or less optimized for DIY etching so the pads are little enlarged and all holes are set to 0.8mm. The design has not been tested yet so you'd better check it out before starting the etch proces. I've done it three times. If there is any error left I'll not see it the nest 999 times (I suppose).

petrus bitbyter

Optically Isolated Unbalanced Audio Line Level Amplifier

  • Please log in to see the project's files and to post contributions or comments to this project.